31 50... Check/change front axle differential oil

Special tools required:

00 2 080

IMPORTANT: If oil is filled up to the lower edge of the oil filler opening, the front axle differential would be overfilled and in rare individual cases oil could emerge from the ventilation opening on the front axle differential.
After draining front axle differential oil or when carrying out the initial filling of a new replacement front axle differential, the transmission must be filled with 600 ml oil.
Use only the approved front axle oil in the front axle differential.
Failure to comply with this requirement will result in serious damage to the front axle differential!

NOTE: Only change oil when front axle differential is at normal operating temperature.

Necessary preliminary tasks:

Remove REINFORCEMENT PLATE .

Checking, correcting front axle differential oil level:

The front axle differential is subject to oil filling over its lifetime. An oil-level adjustment is not needed during a service. If there is a visible leakage of oil or after a repair to the front axle differential, follow the instructions in "Replacing front axle differential oil"!

Fig 1: Identifying Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Changing front differential oil:

Place oil collecting apparatus underneath.

Remove oil drain plug (1).

Tightening torque: 31 50 2AZ .

Drain front axle differential oil.

Screw in oil drain plug (1) and tighten.

Undo oil filler plug (2).

Tightening torque: 31 50 2AZ .

Fill 600 ml of transmission oil. (if necessary, use measuring cup and special tool 00 2 080 )

Fig 2: Identifying Oil Drain Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Renew oil drain plug (1) and oil filler plug (2).