61 31 342 Removing and installing/renewing gear selector switch
IMPORTANT:
Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .
Necessary preliminary tasks:
- Clamp off battery lead from negative connection point . See 61 20 900 DISCONNECTING AND CONNECTING BATTERY EARTH LEAD or 61 20 900 DISCONNECTING AND CONNECTING BATTERY NEGATIVE LEAD .
- Remove CENTER CONSOLE TRIM
Release screws (1).
Tightening torque: 61 31 1AZ .
Installation note:
Insert gear selector switch (2) correctly in front and rear fixation of center console support (3).
Lift gear selector switch (2) and unlock plug connection (1) at gear selector switch (2) and disconnect.
Replacement:
Carry out VEHICLE PROGRAMMING/CODING .