12 61 285 Removing and installing/replacing oil level sensor for engine oil (N20, N26)

IMPORTANT: READ and comply with notes on protection against electrostatic discharge (ESD protection).

Necessary preliminary tasks:

Unlock connector (1) and remove.

Unfasten screws (2).

Tightening torque: 12 61 2AZ .

Remove oil level sensor (3).

Installation note:

Clean sealing surface on oil sump.

Replace seal on oil level sensor.

An excessively low torque value will result in oil leaks.

An excessively high torque value will result in damage to the oil level sensor.

Top up engine oil.

Fig 1: Identifying Connector, Screws And Oil Level Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Delete fault memory.