11 61 365 Removing and installing/replacing left-hand charge air duct (N55 hybrid car)

WARNING: Compliance with the following points is mandatory before beginning work:

Necessary preliminary work:

Installation note:

Ensure locking clamps are correctly fitted.

Lock must engage.

Fig 1: Identifying Charge Air Duct Locking Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and pull off cable connector (1).

Unlock snap fastener (2).

Pull off charge air duct (3) from throttle body.

Fig 2: Identifying Charge Air Duct And Snap Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip charge air duct (1) from rubber grommet (2).

Fig 3: Identifying Charge Air Duct And Rubber Grommet

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock snap fastener (1).

Pull off charge air duct (2) from charge air cooler (3).

Installation note:

The seal inside the snap fastener must be coated with anti-friction agent.

Charge air duct (2) must snap audibly into place!

Fig 4: Identifying Charge Air Duct, Charge Air Cooler And Snap Fastener

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.