11 13 000 Removing and fitting, sealing or replacing the oil sump (N20 all-wheel drive vehicle)
Necessary preliminary tasks:
- Drain and add ENGINE OIL .
- Remove FRONT AXLE DIFFERENTIAL .
- Remove BEARING SUPPORT .
Disconnect plug connection on oil level sensor.
Release screws (1) and remove brackets for engine oil pipe.
Release bolts along line (2).
Tightening torque: 11 13 4AZ
If applicable, remove or reposition oil level sensor.
Tightening torque, 11 13 7AZ .
If applicable, remove or reposition bearing support.
Installation note:
Replace O-ring.
IMPORTANT:
There must be no adhesive residues in the lower crankcase section retaining threads.
Clean retaining threads and sealing surfaces.
Installation note:
Replace gasket (1).
Assemble engine.