11 36 Variable camshaft control VANOS
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - VARIABLE CAMSHAFT CONTROL VANOS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Hexagon screws (central bolts) VANOS with sensor gear to inlet and exhaust camshafts. |
N52K | M10 x 94 | Replace screws. Grip inlet and exhaust camshafts at dihedron when tightening. Jointing torque and angle of rotation must be observed without fail. Jointing torque |
20 Nm |
| Torque angle | 180 ° | ||||
| 2AZ | Non-return valve Non-return valve for VANOS to cylinder head | N52K | M14 x 1.5 | Replace sealing ring. | 13 Nm |
| 3AZ | Hexagon screws Inlet and exhaust solenoid valve with holder to cylinder head. | N52K | M6 x 12 | Replace support and sealing rings. | 9 Nm |