11 28 Ribbed V-belt with tension and deflection system
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - RIBBED V-BELT WITH TENSION AND DEFLECTION SYSTEM
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | ASA screw Belt tensioner to crankcase. Aluminium screws/bolts are permitted with and without colour coding (blue). |
N52K/Nicht fur E70 N52K B30 | M11 x 65 | Replace screw. Thread repairs are not permitted! Jointing torque and angle of rotation must be observed without fail. Jointing torque |
25 Nm |
| Torque angle | 90 ° | ||||
| 2AZ | ASA screw Belt tensioner with deflection pulley to crankcase. Aluminium screws/bolts are permitted with and without colour coding (blue). |
E70 N52K B30 | M11 x 99 | Replace screw. Thread repairs are not permitted! Jointing torque and angle of rotation must be observed without fail. Jointing torque |
25 Nm |
| Torque angle | 90 ° | ||||
| 3AZ | Hexagon screw Deflection pulley to alternator. |
N52K | M10 x 45 | 40 Nm | |