11 41 Oil Pump with Strainer and Drive

WARNING: This page is about a different variant/trim than selected.

TIGHTENING TORQUE SPECIFICATION - OIL PUMP WITH STRAINER AND DRIVE

		Type	Thread	Tightening specification	Measure
1AZ	ASA screws Suction pipe to bedplate. Aluminium screws/bolts are permitted with and without colour coding (blue).	N52K	M6 x 30	Replace screws. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque	4 Nm
				Torque angle	100 °
2AZ	ASA screw Oil pump to bedplate. Aluminium screws/bolts are permitted with and without colour coding (blue).	N52K	M8 x 123	Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque	10 Nm
				Torque angle	180 °
3AZ	ASA screws Oil pump to bedplate. Aluminium screws/bolts are permitted with and without colour coding (blue).	N52K	M8 x 31	Replace screws. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque	10 Nm
				Torque angle	90 °
4AZ	ASA screw Chain module to crankcase. Aluminium screws/bolts are permitted with and without colour coding (blue).	N52K	M6 x 16	Replace screw. Thread repairs are not permitted! Jointing torque and angle of rotation must be observed without fail. Jointing torque	4 Nm
				Torque angle	45 °
5AZ	ASA screws Chain module to oil pump. Aluminium screws/bolts are permitted with and without colour coding (blue).	N52K	M6 x 16	Replace screws. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. Jointing torque	4 Nm
				Torque angle	45 °
6AZ	Fillister head bolt Sprocket wheel to oil pump.	N52K	M8 x 20	Jointing torque and angle of rotation must be observed without fail. Jointing torque	20 Nm
				Torque angle	45 °