11 22 Flywheel
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - FLYWHEEL
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Hexagon screws Flywheel to crankshaft for automatic transmission. |
N52K | M12 x 25.5 | Replace screws. Jointing torque and final tightening must be observed without fail. 1. Jointing torque |
30 Nm |
| 2. Final tightening | 125 Nm | ||||
| 2AZ | ISA screws Flywheel to crankshaft for manual gearbox. |
N52K | M12 x 25 | Replace screws. | 120 Nm |