11 21 Crankshaft and Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Hexagon screw (central screw) Hub of vibration damper to crankshaft. |
N52K | M16 x 80 | Replace screw. Screw and thread are lightly oiled. Jointing torque and angle of rotation must be observed without fail. Jointing torque |
100 Nm |
| Torque angle | 360 ° | ||||
TIGHTENING TORQUE SPECIFICATION - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Increment wheel on crankshaft | S54 | M5 10.9 | Replace screws Jointing torque |
5.0 Nm |
| Torque angle | 45 ° | ||||
| Increment wheel on crankshaft | M5 10.9 | Replace screws | 13 Nm | ||
| Increment wheel on crankshaft | M5 8.8 | Replace screws | 5.5 Nm | ||