11 24 Connecting Rods and Bearings
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CONNECTING RODS AND BEARINGS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | ASA screw (connecting rod bolt) Connecting rod bearing cap to connecting rod. |
N52K | M8 x 47 | Replace screw. Screw washed and oiled. Jointing torque and angle of rotation must be observed without fail. Jointing torque |
20 Nm |
| Torque angle | 70 ° | ||||