11 31 Camshaft
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - CAMSHAFT
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | ASA screws Upper and lower bearing banks of exhaust camshaft to cylinder head. |
N52K | M7 x 70 | Insert bolts dry. Tighten screws from inside outwards. Jointing torque and angle of rotation must be observed without fail. Jointing torque |
20 Nm |
| Torque angle | 70 ° | ||||
| 2AZ | ISA screws Bearing cap of intake camshaft to cylinder head. |
N52K | M6 x 30.5 | 9 Nm | |
| 3AZ | ASA screws Timing chain module to cylinder head. |
N52K | M6 x 35 | 9 Nm | |
| 4AZ | Bearing pin Timing chain module to crankcase. |
N52K | M8 | 20 Nm | |
| 5AZ | Bearing pin Timing chain module to cylinder head. |
N52K | M7 | 14 Nm | |
| 6AZ | Chain tensioner Chain tensioner to cylinder head. |
N52K | M22 x 1.5 | Replace sealing ring. | 55 Nm |
| 7AZ | Plug Assembly opening to cylinder head. |
N52K | M18 x 1.5 | 25 Nm | |