11 25 Pistons with Rings and Pins N52K B30
WARNING: This page is about a different variant/trim than selected.
PISTONS WITH RINGS AND PINS SPECIFICATION
| 1st groove | ||
| End clearance | mm | 0.150... 0.300 |
| Axial play | mm | 0.020... 0.070 |
| 2nd groove | ||
| End clearance | mm | 0.300... 0.500 |
| Axial play | mm | 0.020... 0.060 |
| 3rd groove | ||
| End clearance | mm | cannot be measured |
| Axial play | mm | cannot be measured |
PISTONS WITH RINGS AND PINS SPECIFICATION
| Piston and pin are paired to each other - replace together only. | ||
| Measuring point "A" (position) | mm | 14 |
| Piston diameter at measuring point "A" | ||
| Original (new dimension) | mm | 84.990±0.010 |
| Repair stage (new dimension) | mm | % |
| Oversize (new dimension) | mm | 85.240±0.010 |
| Piston installation clearance (piston new) | mm | 0.000...0.034 |
| Piston installation clearance (piston worn) | mm | 0.020...0.047 |
| Permissible total wear tolerance between piston and cylinder (engine operated) |
mm | 0.150 |