11 11 Engine Block, Cylinder Crankcase N52K B30
WARNING: This page is about a different variant/trim than selected.
ENGINE BLOCK, CYLINDER CRANKCASE SPECIFICATION
| Bore | stage 0(1)) | mm | 85.000+0.014 | ||
| Bore | stage 00 (1)) | mm | |||
| Bore | stage 1 (1)) | mm | 85.250+0.014 | ||
| Permitted out-of-round of cylinder bore (1)) | mm | 0.005 | |||
| Permitted conicity of cylinder bore (1)) | mm | 0.010 | |||
| Permissible total wear tolerance between piston and cylinder (engine operated) | mm | 0.150 | |||
|
|||||