26 11 051 Replacing flexible disk for front propeller shaft

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks:

NOTE: To protect universal joints, tie back propeller shaft in area of center mount.

Release screws and remove flexible disc (1) from propeller shaft.

IMPORTANT: Replace shiny ZNS bolts and self-locking nuts.

Tightening torque and angle of rotation: 26 11 1AZ .

Installation:

Arrows (3) on circumference of flexible disk must point to flange arms (2).
Grip mounting bolts of flexible disk at propeller shaft flange at nuts and tighten down at bolt heads.

Fig 1: Locating Flexible Disc Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Check centering mount.

Replace damaged CENTERING MOUNT .

Fig 2: Locating Centering Mount

Courtesy of BMW OF NORTH AMERICA, INC.