26 11 020 Replacing center mount gaiter

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks

Remove PROPELLER SHAFT .

NOTE: The propeller shaft is balanced. The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).

Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.

Fig 1: Identifying Front And Rear Propeller Shaft Marks

Courtesy of BMW OF NORTH AMERICA, INC.

Pull propeller shaft apart.

Fig 2: Identifying Front And Rear Propeller Shaft Marks Pulling Propeller Shaft Apart

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

If necessary, insert new clamping ring (1) into front propeller shaft (2).

Fig 3: Identifying Front Propeller Shaft With Clamping Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release gaiter (1) with screwdriver from groove (2) and pull off over longitudinal splines.

Installation:

Apply an even coating of grease to longitudinal splines on shaft. See PROPELLER SHAFT - OPERATING FLUIDS

Observe markings and force front propeller shaft onto longitudinal splines (markings must be flush).

Push gaiter (1) during installation into groove (2) and make sure it is firmly seated.

Fig 4: Identifying Gaiter And Groove

Courtesy of BMW OF NORTH AMERICA, INC.