24 00 050 Installing replacement transmission (GA6HP19Z)
WARNING: This page is about a different variant/trim than selected.
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ .
IMPORTANT:
After completion of work, program control unit for transmission.
Recycling
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
IMPORTANT:
- Before installing replacement transmission, always flush TRANSMISSION FLUID COOLER TOGETHER WITH LINES .
- After completion of work, check TRANSMISSION OIL LEVEL .
Replacement transmission is supplied filled with transmission fluid.
Use only the approved AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks
- Remove AUTOMATIC TRANSMISSION .
NOTE:
If necessary
Release screws.
Remove and convert transmission bearing block (1).
Tightening torque 24 71 6AZ .
Convert transportation lock (1).
Convert all cable holders.
Convert all seal plugs.
Convert protective cap on output shaft.
IMPORTANT:
After removing transportation lock, secure torque converter against slipping out.
Transmission identification:
- refer to BMW Parts Department.
- On type plate