13 54 030 Removing and installing/sealing throttle valve assembly (N52K)

WARNING: This page is about a different variant/trim than selected.

Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD protection).

Necessary preliminary tasks

Unlock plug (1) and remove.

Release screws.

Tightening torque 13 54 1AZ .

Remove throttle assembly (2).

Fig 1: Identifying Plug And Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation

Replace sealing ring (1) of throttle assembly (2).

Fig 2: Identifying Sealing Ring And Throttle Assembly

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check stored fault messages.

Now clear the fault memory.