11 36 655 Removing and installing/replacing both solenoid valves (N52K)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: It is essential to observe conditions of absolute cleanliness when removing and installing the inlet and exhaust solenoid valves.
Possible malfunction if valves are contaminated:

Rough running
OBD fault entry
Exhaust emission characteristics
Low engine power

Necessary preliminary tasks:

Remove FAN COWL (E89 only)

Disconnect plug connection (1) on inlet solenoid valve (2).

Release screw (3).

NOTE: Secure support and sealing ring against falling down.

Remove inlet solenoid valve (2) with bracket towards front.

Disconnect plug connection (6) on exhaust solenoid valve (5).

Release screw (4).

NOTE: Secure support and sealing ring against falling down.

Fig 1: Identifying Solenoid Valve, Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Remove exhaust solenoid valve (5) with bracket towards front.

Tightening torque 11 36 3AZ .

IMPORTANT: Risk of mixing up plug connections (1 and 6).

Installation:

Replace support and sealing rings.

Assemble engine.

Check function of DME.