Mounting engine on assembly stand (N52K)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
Aluminum screws/bolts must be replaced each time they are released
.
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
The end faces of aluminum screws/bolts are painted blue for the purposes of reliable identification.
Jointing torque and angle of rotation must be observed without fail (risk of damage) .
Necessary preliminary tasks:
- Remove engine
Bolt engine or engine block with steel bolts (1) and aluminum bolts (2) to special tool 11 4 440 .
To release central bolt, bolt on special tools 11 9 261 and 11 9 265 as well.
Mount engine with special tool 11 3 370 to special tool 00 1 450.