12 14 524 Replacing pulse generator on exhaust camshaft (N52K)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Unlock plug (1) and remove.

Release screw.

Installation:

Replace screw.

Tightening torque 13 62 1AZ .

Remove pulse generator (2).

Fig 1: Identifying Plug And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Now clear the fault memory.