23 00 038 Installing replacement transmission (GS6-17BG/DG)
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
After completion of work, check TRANSMISSION OIL LEVEL
.
Use only approved transmission oil. See MANUAL TRANSMISSION - OPERATING FLUIDS .
Use only approved transmission oil. See MANUAL TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this instruction will result in serious damage to the transmission.
Recycling
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks
- Drain gear oil at oil drain plug. Tightening torque:23 00 4AZ
- Remove TRANSMISSION
Transfer shift-rod joint.
Slide back retaining ring (1) and drive out cylinder pin (2).
NOTE:
Check damping disk (6) for damage and replace if necessary.
Convert following parts from previous transmission to new transmission.
- RELEASE BEARING AND RELEASE LEVER
- Ball pin and spring wire clip
- Studs for clutch slave cylinder
- Reversing light switch, tightening torque: 23 11 1AZ
Add final details to vehicle.
Check oil level.
Installation:
Observe GREASING SPECIFICATION .