12 41 Starter motor with mounting
WARNING: This page is about a different variant/trim than selected.
TIGHTENING TORQUE SPECIFICATION - STARTER MOTOR WITH MOUNTING
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Starter motor mounting to crankcase | N52K | M10x85 | Replace screw | |
| Jointing torque | 20 Nm | ||||
| Torque angle | 180 ° | ||||
| 2AZ | Starter motor mounting to crankcase | N52K | M10x30 | Replace screw | |
| Jointing torque | 20 Nm | ||||
| Torque angle | 90 ° | ||||