33 41 151 Replacing left or right wheel bearing on rear axle shaft

IMPORTANT: Do not damage multipole impulse ring.

Fig 1: Identifying Multipole Impulse Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Release screws.

Remove wheel bearing.

Installation:

Stick in screws again/replace.

Tightening torque 33 41 2AZ .

Fig 2: Locating Wheel Bearing Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep contact surface (2) of wheel bearing/wheel carrier clean and free from oil and grease.

Except when replacing: Recondition tapped holes (1).

Install new wheel bearing.

Fig 3: Identifying Contact Surface Of Wheel Bearing/Wheel Carrier And Tapped Holes

Courtesy of BMW OF NORTH AMERICA, INC.

After installation: