41 11 516 Replacing Left Carrier Support (Partial Replacement, Front Side Panel Removed)

Read contents of BODY, GENERAL .

Remove or cover those vehicle components in the repair area which are susceptible to heat or dust.

Use only approved spot-welding apparatus  for repairs, see WORKSHOP EQUIPMENT .

Place vehicle on straightening bench.

Following new body parts are required:

• (1) Support carrier, wheel arch, front,

Fig 1: Identifying Support Carrier, Wheel Arch, Front,

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in area (1).

Fig 2: Identifying Weld Joint Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Open weld joints in areas (1).

Fig 3: Identifying Weld Joint Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut in accordance with measurement a and cut support carrier.

Measurement a=50 mm before 20 mm dia. bore

Installation: 

Adjust new part to fit with straightening attachment or universal mount.

Weld in reinforcement plate  at severance cut, see 41 00... Welding in reinforcement plate (steel plate) .

Fig 4: Identifying Cut Mark Area

Courtesy of BMW OF NORTH AMERICA, INC.