New Part Preparation

WARNING: This page is about a different variant/trim than selected.

Adjust new part in combination with tail panel and side wall to fit and secure.

In areas (1) to (3), set 4.2 mm diameter bore holes for blind rivets N3:

Fig 1: Identifying Blind Rivets Areas

Courtesy of BMW OF NORTH AMERICA, INC.

In areas (1) to (3), set 4.2 mm diameter bore holes for blind rivets N3:

Remove new part again and deburr bore holes.

Fig 2: Identifying Blind Rivets Areas

Courtesy of BMW OF NORTH AMERICA, INC.

Set four 4.2 mm dia. bore holes for blind rivets N3 in area (1).

Remove new parts again and deburr holes.

NOTE: Side wall hidden for purposes of clarity.

Fig 3: Identifying Blind Rivets Area

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not grind new part and body in area of bonding surfaces.