41 61 000 Removing And Installing Engine Compartment Lid
WARNING: This page is about a different variant/trim than selected.
WARNING:
Danger of injury! Support engine hood in fully opened position with suitable apparatus.
IMPORTANT:
Removal of the hood/bonnet must be carried out with the assistance of a second person.
NOTE:
Carry over schematic representation to the relevant vehicle type.
Release nuts (1).
Tightening torque 41 61 1AZ , see 41 61 ENGINE BONNET/HOOD .
Remove hood lid.
Installation:
Install engine hood at screw locations to on hinge. This dispenses with the need for adjustment after installation.
If this is not possible, adjust ENGINE HOOD