41 05 800 Releasing Bonded Folded Seam Connections

WARNING: This page is about a different variant/trim than selected.

Fig 1: Releasing Bonded Folded Seam Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Remove area (1) of bead edge on wheel arch bend with a one-hand angle grinder and rough grinding wheel.
Heat area (2) with hot air blower.
CAUTION: Extract vapors and gases.
Release connection flange with chisel.
Grind adhesive residue (4) off wheel arch connection flange.
CAUTION: Wear a grinding dust mask.
Remove remnants of sealing material in area (3).

Fig 1: Identifying Bead Edge On Wheel Arch Bend

Courtesy of BMW OF NORTH AMERICA, INC.

Remove area (1) of bead edge on wheel arch bend with a one-hand angle grinder and rough grinding wheel.
Heat area (2) with hot air blower.
CAUTION: Extract vapors and gases.
Release connection flange with chisel.
Grind adhesive residue (4) off wheel arch connection flange.
CAUTION: Wear a grinding dust mask.
Remove remnants of sealing material in area (3).