41 00... Installing A Cavity Acoustic Baffle (Not Expanded)
WARNING: This page is about a different variant/trim than selected.
NOTE:
Carry over schematic representation to the relevant vehicle type.
The following repair represents replacement of a cavity acoustic baffle.
Before these work steps, prepare the new part so that it is ready to install (adapting, cutting to size, applying welding primer etc.).
The following repair represents replacement of a cavity acoustic baffle.
Before these work steps, prepare the new part so that it is ready to install (adapting, cutting to size, applying welding primer etc.).
Sand contact surface of cavity acoustic baffle (1) with coarse-grained abrasive paper (grain 50 - 100).
Clean contact surface (1) with spirit.
Apply a bead approx. 15 mm high of SEALANT D1 to contact surface (1).
If necessary apply sealant D1 somewhat thinner on each side, to prevent the sealant from running.
Attach cavity sealing in specified position (see used part).
Fit, secure and weld up new part.
WARNING:
Ensure adequate ventilation over entire processing period.