Condition for fault identification

Test condition:

The fault is recognized when, following a recognized operating status, the vehicle stops and no signal from the clutch switch is detected. The following conditions must be recognized for the operating status: longer than 3 sec., v > 30 km/h, n > 1510 RPM, load must be present, for instance, by accelerating from standing start in second gear

Potential problem source(s):

• Driving with clutch slipping
• Defective wiring harness
• Clutch switch defective

Terminal condition: none

Voltage condition:

• Electrical system voltage > 10 V

Temperature condition:

• None

Time condition:

• None

Other conditions:

• see 'Conditions for logging diagnostic fault code'