13 62 591 Removing and installing/replacing brake pressure sensor on left after cooler (N63 hybrid)
WARNING:
High-voltage system - danger to life!
WARNING:
The following points must be strictly observed prior to starting work:
- DE-ENERGIZE THE HIGH-VOLTAGE SYSTEM
- Observe SAFETY INSTRUCTIONS for handling with hybrid vehicles
Necessary preliminary tasks:
- Read out fault memory of DME control unit
- Turn off ignition
- Remove FAN COWL
Unlock plug (1) and remove.
Unfasten screws (2).
Tightening torque 13 62 7AZ .
Pull pressure sensor (3) out of left charge air cooler.
Installation note:
Replace sealing ring on pressure sensor.
Installation note:
Delete fault memory.