11 13 020 Removing and installing/replacing lower oil sump section (N63 hybrid)
WARNING:
High-voltage system - danger to life!
Necessary preliminary tasks:
- Remove REINFORCEMENT PLATE
- REMOVE OIL DRAIN PLUG and drain engine oil.
Unlock plug connection (1) on oil level sensor and disconnect.
Release screws (2) along line.
Tightening torque 11 13 2AZ .
Remove lower oil sump section (3).
Installation:
Clean sealing surfaces.
Replace seal.
Replace screws.
When replacing oil sump bottom section:
Convert oil level sensor.
Replace sealing ring.