11 65 010 Removing and installing/replacing pressure accumulator (N63 Hybrid)
WARNING:
High-voltage system - danger to life!
Necessary preliminary tasks:
- Remove both exhaust turbochargers. See TURBOCHARGER, RIGHT, CYLINDERS 1-4 and TURBOCHARGER, LEFT, CYLINDERS 5-8 .
- Remove both EXHAUST MANIFOLDS
- Remove HEAT SHIELD at bottom
Release banjo bolt (1).
Tightening torque 11 42 3AZ .
Installation:
Replace sealing ring.
Release screw (3) on engine oil line.
Remove engine oil line (2).
Release screws (3) on vacuum reservoir (4).
Tightening torque 11 65 6AZ .
Remove vacuum reservoir (4).
Check VACUUM CONNECTIONS for correct routing.
Check vacuum system for leaks.
Assemble engine.