11 14 250 Removing and installing/sealing rear coolant end cover (N63 hybrid)

Special tools required:

WARNING: High-voltage system - danger to life!

WARNING: Danger of scalding!
Only perform this work after engine has cooled down.

Recycling:

Catch and dispose of drained coolant in a suitable container.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks:

Release all screws in area (1).

Tightening torque 11 14 5AZ .

Remove end cover.

NOTE: Clean sealing surfaces with special tool 11 4 470 .

Fig 1: Identifying End Cover Screws In Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Replace profile seal (1).

Fig 2: Identifying Profile Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.