34 41 220 Removing and installing/renewing all parking brake pads
Special tools required:
- 34 4 000
Installation note:
- REMOVE rear brake disk.
- Release electromechanical parking brake (EMF).
After completing repair work, ADJUST PARKING BRAKE .
NOTE:
During replacement of the hand brake coverings, the following components must also be renewed:
- Brake shoe expander
- Adjusting screw
- Spring set
Disconnect return springs (1) with brake spring pliers.
Installation note:
Return springs (1) must not be over-elongated.
Check return springs (1) and replace if necessary.
Return springs (1) must not be mixed up.
Pay attention to installation position of adjusting screw (2).
Apply a thin coat of grease to bush and screw threads.
NOTE:
Graphic without wheel hub.
Twist roll pins (1) 90° with special tool 34 4 000 and detach.
Remove brake pads (2).