13 62 Senders for Control Unit
WARNING: This page is about a different variant/trim than selected.
SENDERS FOR CONTROL UNIT - TIGHTENING TORQUE SPECIFICATIONS
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Temperature sensor, coolant/oil | N63 | M12 x 1.5 | 13.5 Nm | |
| 2AZ | Pressure sensor to intake manifold | N63 | K50 x 14 | 3.5 Nm | |
| 3AZ | Camshaft sensor to cylinder head | N63 | M6 | 9 Nm | |
| N63 | K50 | 5 Nm | |||
| 4AZ | Crankshaft sensor to transmission | N63 | M6 | 9 Nm | |
| 5AZ | Knock sensor to crankcase | N63 | M8 | 21.5 Nm | |
| 6AZ | Air-mass flow sensor to upper section of intake filter housing | N63 | K50 x 16 | 3 Nm | |
| 7AZ | Pressure sensor to intercooler | N63 | M6 | 4 Nm | |