LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> X6 35i >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine - Repair (N63)) >> Intake Manifold >> 11 61 730 Check BMW diagnosis system for excess pressure and vacuum (N63) >> Vacuum pressure measurement

Vacuum pressure measurement

WARNING: This page is about a different variant/trim than selected.

Prepare diagnosis tester on vacuum diagnosis unit.

  1. Screw in pressure sensor.
  2. Connect stimuli cables (2) to positive and negative.
  3. Connect 12V battery cables (3) to vehicle battery positive and negative.
  4. Controller for vacuum connection.
  5. Vacuum connection (Red).
    Fig 1: Measuring Vacuum Pressure
    G06888831Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals