51 71 482 Removing and installing/replacing left or right trailing link (on rear axle) (from 03/2007)
IMPORTANT:
Observe SAFETY INFORMATION
for raising the vehicle
Driving without the trailing link is not permitted!
Driving without the trailing link is not permitted!
Left tension strut:
Release bolts (1, 3, 4, 5) and remove left trailing link (2).
Installation note:
Make sure screws are installed in correct positions.
- Screw (1) M12x35
Tightening torque 51 71 21AZ .
- Screw (3) M12x50
Tightening torque 51 71 22AZ .
- Screw (4) M10x25
Tightening torque 51 71 23AZ .
- Screw (5) M10x25
Tightening torque 51 71 20AZ .
Right tension strut:
NOTE:
Remove left trailing link.
Release screws (1, 3) and remove right trailing link (2).
Installation note:
Make sure screws are installed in correct positions.
- Screw (1) M12x35
Tightening torque 51 71 21AZ .
- Screw (3) M10x25
Tightening torque 51 71 20AZ .