34 11 Front Brake
TIGHTENING TORQUE SPECIFICATIONS - FRONT BRAKE
| Type | Thread | Tightening specifications | Value | |
|---|---|---|---|---|
| 1AZ Brake disc to wheel hub | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | M8 | Replace screws. | 16 Nm |
| 2AZ Brake anchor plate to swivel bearing | F01, F02, F04, F06, F07, F10, F11, F12, F13, F18 | M12x1.5 | 110 Nm | |
| F03 | M14x1.5 | Replace screws. Important: Observe 4 phase tightening! |
||
| Jointing torque | 150 Nm | |||
| Release | min.90 ° | |||
| Jointing torque | 150 Nm | |||
| Angle of rotation | 180°± 15° | |||
| F25 | M12x1.5 | Replace screws. | ||
| Jointing torque | 75 Nm | |||
| Angle of rotation | 45°10° | |||
| 3AZ Guard plate to swivel bearing | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | M6 | Replace screws. | 12 Nm |
| 4AZ Guide bolt (brake caliper to brake anchor plate) | F01, F02, F03, F04, F06, F07, F10, F11, F12, F13, F18, F25 | SW9 | 55 Nm | |
| F07, F06, F10, F11, F12, F13, F18, F25 | SW7 | 30-5 Nm | ||
| 5AZ Brake caliper at swivel bearing | F10 / F12 / F13 / Nur M-Modelle | M12x1.5 | Hexagon nut | 95 Nm |
| 6AZ Stud bolt (for brake caliper) in wheel carrier | F10 / F12 / F13, Nur M-Modelle | Clean the thread in the wheel carrier and renew the stud bolt | 20 Nm |