51 12 825 Removing and installing/replacing guide for rear center bumper
Necessary preliminary tasks:
- Remove REAR BUMPER TRIM .
- If necessary, remove SENSOR FOR LANE CHANGE WARNING .
NOTE:
Operation is described on the left side.
The operation on the right side is the same as for the left side.
The operation on the right side is the same as for the left side.
Release screw (1).
Slacken nut (2).
Tightening torque 51 12 2AZ .
Installation note:
Note line routing.
Unscrew nuts (1).
Tightening torque 51 12 2AZ .
If necessary, remove plug connection on bumper aerial for comfort access system.
Feed out guide (2) and remove.
Replacement:
- Remove BUMPER AERIAL for comfort access system.