51 71... Removing and installing/replacing (front) left or right suspension crossbrace
IMPORTANT:
Driving without the suspension cross-brace is not permitted. (risk of damage to the body).
Tighten screw on suspension cross-brace to torque. Then tighten to angle of rotation, special tool 009120 TORSION ANGLE GAUGE .
Release screws (1).
Tightening torque 51 61 2AZ
Remove suspension cross-brace (2).
Installation note:
Make sure suspension cross-brace (2) is in correct installation position. Screw with washer is fitted at connection, front top.