12 14 523 Replacing pulse generator on inlet camshaft (N54)

IMPORTANT: Aluminium screws/bolts must be replaced each time they are released.

Aluminium screws/bolts are permitted with and without color coding (blue).

For reliable identification:

Jointing torque and angle of rotation must be observed without fail (risk of damage).

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Release screws (1).

Tightening torque 13 62 6AZ .

Slide cable duct (2) to one side.

Fig 1: Identifying Cable Channel And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug (1) and remove.

Release screw.

Tightening torque 13 62 3AZ .

Remove pulse generator (2).

Fig 2: Locating Pulse Sensor Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault message.
Now clear the fault memory.