66 32 020 Removing and installing/replacing sensor for lane change warning (HC2 sensor) on left or right
Necessary preliminary work:
- Remove REAR BUMPER TRIM
Disconnect plug connection (1).
Unfasten screws (2).
Remove HC2 sensor (3).
IMPORTANT:
If, in the event of side damage to the vehicle, it is not necessary to replace the tail panel, observe the following points:
Fit middle bumper panel guide on undamaged side.
Use middle bumper panel guide as a gauge in order to check or correct the position of the remaining connecting points.
Middle bumper panel guide must be able to be fitted without tension.
Replacement:
- Carry out VEHICLE PROGRAMMING AND ENCODING .
Replacement/after body repair:
- Execute diagnosis job
- Initial operation
- Lane change warning sensor system