61 31 357 Removing and installing (renewing) gear selector switch (M5 with twin-clutch gearbox)

IMPORTANT: Read and comply with notes on protection against electrostatic discharge (ESD PROTECTION) .

Necessary preliminary tasks:

Release screws (1).

Tightening torque 61 31 1AZ .

Installation note:

Insert gear selector switch (2) correctly in front and rear fixation of center console support (3).

Fig 1: Locating Gear Selector Switch And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise the gear selector switch (1).

Unlock and disconnect plug connection (2) at gear selector switch (1).

Fig 2: Identifying Gear Selector Switch

Courtesy of BMW OF NORTH AMERICA, INC.