27 10 050 Replacing output flange for front axle output (ATC 300)
IMPORTANT:
Do not move vehicle with drive power once propeller shaft has been removed.
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved transmission fluid. See TRANSFER BOX - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Replace output flange only in conjunction with a new radial shaft seal.
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved transmission fluid. See TRANSFER BOX - OPERATING FLUIDS .
Failure to comply with this requirement will result in serious damage to the transfer box!
Operation is identical to REPLACING RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT .