62 11 280 Removing and installing (replacing) instrument cluster

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

IMPORTANT: Risk of damage!
Carry out this operation carefully so as to avoid damaging the instrument panel.

Extend steering wheel completely and lower.

Release screws (1). Tightening torque 62 11 1AZ .

Pull instrument cluster (2) forward slightly in direction of arrow.

Fig 1: Pulling Instrument Cluster Forward Slightly

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect associated plug connection.

If necessary, feed out/unclip associated wiring harness.

Remove instrument cluster (2).

Replacement:

Check values for CONDITION BASED SERVICE (CBS) and correct if necessary.