LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2011 >> 335i 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 42 (Airbag, Audio, Navigation And Anti-Theft - Repair - E90) >> On-Board Computer, Outside Temperature Sensor >> 65 81 060 Removing and installing/replacing outside temperature sensor

65 81 060 Removing and installing/replacing outside temperature sensor

WARNING: This page is about a different variant/trim than selected.

Necessary preliminary tasks 

Partially remove COOLING AIR DUCT AT TOP left.

Disconnect plug connection (1).

Snap out outside temperature sensor in direction of arrow and remove.

Installation: 

Outside temperature sensor must audibly snap into place.

Check for secure seating after fitting.

Fig 1: Disconnecting Plug Connection
G04753749Courtesy of BMW OF NORTH AMERICA, INC.