65 83 590 Removing and installing/replacing gyro sensor drive for Car Communication Computer

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks

Remove CAR COMMUNICATION COMPUTER .

If necessary, cut through warranty seal.

Release bolts (1).

Remove floor pan (2) towards bottom and set down.

IMPORTANT: Contact spring strip (3) on floor pan (2) must not be bent: otherwise risk of short-circuiting!
When reinstalling floor pan (2), make sure individual springs of contact spring strip (3) are correctly seated.

Fig 1: Identifying Floor Pan And Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1).

Detach gyro sensor for Car Communication Computer (2) in direction of arrow from plug-in contact (3).

Fig 2: Detaching Gyro Sensor For Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.