65 83 560 Removing and installing/replacing front trim for Car Communication Computer

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks

Release screws (1).

Fold down front panel for Car Communication Computer (2) and set down.

Installation:

Make sure retaining lugs (3) of front panel for Car Communication Computer (2) are correctly seated.

Fig 1: Removing Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: "LIF" stands for Low Insertion Force.

Open catch of LIF plug (2) in direction of arrow and feed out LIF cable (1).

Remove front trim for Car Communication Computer (4) from Car Communication Computer (3).

Fig 2: Removing Front Trim For Car Communication Computer

Courtesy of BMW OF NORTH AMERICA, INC.