66 20 508 Removing and installing (replacing) control unit (Park Distance Control)

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Release screws (1) and pull back device holder (2).

Fig 1: Pulling Back Device Holder

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Unlock catch (2) in direction of arrow and remove control unit (3) upwards from device carrier (4).

Fig 2: Removing Control Unit Upwards From Device Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: